New ergonomically arranged two-hand cut start

with new programmable touch function. The need to press two levers for the duration of the down-stroke is no longer required , Allowing stress-free working for hours.

Backgauge positioning by electronic hand wheel

with high-precision and easy handling.

Backgauge drive by servo motor (30 resp. 200 cm / sec)

Quick positioning of cutting stock with up to 30 cm / sec, as from 76 - type and up to 200 cm / sec (in backgauge return mode) in case of the system machine with linear drive. Backgauge-speed, -acceleration and -braking are adjustable. Particularly advantageous when processing sensitive cutting stock.

Optimised cutting cycle

Unnecessary waiting times are eliminated, the cutting cycle speed is increased by over 30 %

Programmable clamp pressure

With clear visualisation of the selected and actual clamp pressure on the display.

Automatic adapting of the clamp pressure to the cutting width.

No longer extreme overclamping of the small sides of the ream, which results in a longer knife life time and higher cutting accuracy. The clear visualizing on the display informs the operator, any time, about the actual clamp pressure.

Automated safety knife change from the front

The knife-change protection device provides highest safety standard for the machine operator. Knife chipping during knife change can be eliminated.

Quick knife-change

New knife-changing device (knife lift with setting gauge) with automatic knife fine-adjustment. Adjusting of the knife carrier and switch-off of main motor can be disregarded.
(Correction of knife thickness ± 0,99 mm)

Higher stability by new machine body cast in one piece
and new table suspension.

The torsion-free cutting unit is ideally suited for high loads,
guaranteeing highest cutting accuracy for decades.

Low-maintenance electromagnetic clutch

with smooth engaging of the main drive, protecting the mechanics and transmission.

Clamp bar stop function

The clamp bar stops close to the material, significantly reducing cycle times.

Solid machine table

2 mm stainless-steel plating on the machine table virtually eliminating the possibility of corrosion which can be caused with nickel and chrome refinement.